| |
TM 10-4320-342-24
4-4. STARTER-GENERATOR REPAIR - continued.
Refer to Figure 4-8.
(11)
Inspect end bell (drive end) (1) as follow:
(a)
Inspect end bell (drive end) (1) for wear or warpage. Replace if worn or warped.
(b)
Measure inside of diameter of liner (2). Replace if inside diameter is not within 1.5745 to 1.5748.
Figure 4-8. End Bell (Drive End) Measurement
Refer to Figure 4-9.
(12)
Inspect end bell assembly (1) as follows:
(a)
Inspect end bell assembly (1) for wear and warpage. Replace if worn or warped.
(b)
Measure inside diameter of liner (2). Replace if inside diameter is not within 1.5747 to 1.5750.
Figure 4-9. End Bell Assembly Measurement
4-13
|