|
| |
TM 10-4320-342-24
4-4. STARTER-GENERATOR REPAIR - continued.
Refer to Figure 4-5.
NOTE
Do not disassemble stator assembly. If terminal block requires replacement,
proceed as follows:
(22)
Remove two nuts (1), washers (2) and leads (3) from studs marked A and D on terminal block (3).
(23)
Remove three nuts (5) and washers (6) from studs marked B, C and E on terminal block (4).
(24)
Remove two screws (7), lockwashers (8), flat washers (9) and disconnect wire terminal (10) from terminal block
(4).
(25)
Disconnect leads (11) from studs B, C and E and remove terminal block (4) from stator (12).
Figure 4-5. Terminal Block Removal
4-10
|
