|
| |
TM 10-4320-342-24
3-19. PUMP AND CLUTCH (600 GPM FUEL PUMPP) REPAIR - continued.
Refer to Figure 3-14.
(23)
Disengage (bend up) tabs (1) on tab washer (2) from nut (3).
(24)
Remove nut (3) and tab washer (2) from end of shaft (4).
(25)
Remove rotor assembly (5) from shaft (4).
(26)
Remove three screws (6) and field retainer plate (7) from field clutch (8).
(27)
Remove field clutch (8) and shim stack (9) from clutch housing (10).
NOTE
To aid in assembly, measure and record thickness of shim stack.
(28)
Press out shaft (4) from clutch housing (10).
(29)
Remove spring tension (wavy ) washer (11) and shim stack (12) from inside of shaft (4).
NOTE
To aid in assembly, measure and record thickness of shim stack.
(30)
Remove three screws (13), bearing retainer (14) from clutch housing (10).
(31)
Press out bearings (15 and 16) from clutch housing (10).
(32)
Remove spring tension (wavy) washer (17), shim stack (18) and bearing spacer (19) from clutch housing (10).
(33)
Remove insert (20) from clutch housing (10).
3-36
|
