|
| |
TM 10-4320-342-24
3-10.
WINCH REPAIR - continued.
Refer to Figure 3-2.
NOTE
To aid in assembly, mark and record position of drum support (2) on housing (6).
(10)
Remove ten screws ,(1). While holding housing (2) and drum support (3) together, position housing on bench
with drum support up.
(11)
Separate drum support (3) and gasket (4) from housing (2).
(12)
Remove seal (5) and bushing (6) from drum support (3).
(13)
Remove two screws (7) and latch (8).
(14)
Remove detent spacer (9), spring (10) and ball (11) from housing (2).
(15)
Remove clutch lever (12) from housing (2).
(16)
Remove preformed packing (13) from lever (12). Discard preformed packing.
(17)
Remove third stage carrier assembly (14) from housing (2).
(18)
Remove second stage carrier assembly (15) from housing (2).
(19)
Remove first stage carrier assembly (16) and sun gear input (17) from housing (2).
(20)
Remove thrust washer (18) from housing (2).
(21)
Remove ring gear (19) from housing (2).
(22)
Remove retaining ring (20) from housing (2).
CAUTION
Steel ball set consist of 85 steel balls and fall out easily. Use care when removing
sliding gear to prevent loss or damage to steel balls.
(23)
Remove sliding ring gear (21) and steel ball set (22) from housing (2).
3-8
|
