|
| |
TM 10-4320-342-24
2-86.
WHEEL, DETENT PIN, GEAR MOUNT AND PIVOT REPLACEMENT.
This Task Covers
a. Removal
b. Service
c. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Sect III,
Wheel Assembly in the Up position (Para 2-6,
Item 1)
TM 10-4320-342-10)
Drain Tank removed (Para 2-15)
Materials/Parts
Lockwashers (App F, Item 41)
NOTE
· The following procedure is typical for the swivel and rigid wheel assemblies.
· This procedure covers three of the four gear mounts. The gear mount located under
the battery compartment is similar but is attached with rivnuts.
· When removing the gear mount located next to the drain tank, removal of the drain
tank is required.
a. REMOVAL. Refer to Figure 2-116.
(1)
Remove wheel assembly (1) by removing nuts (2), lockwashers (3), flatwashers (4) and screws (5).
(2)
Pull detent pin (6) and slide pivot (7) off gear mount (8).
(3)
Remove detent pin (6) and gear mount (8) by removing nuts (9), lockwashers (10), flatwashers (11) and screws
(12).
b. SERVICE.
Refer to LO 10-4320-342-10 for servicing of wheel assembly.
c. INSTALLATION.
(1)
Install detent pin (6) and gear mount (8) onto frame with screws (12), flatwashers (11), lockwashers (10) and nuts
(9).
(2)
Slide pivot (7) on gear mount (8), align holes and insert detent pin (6).
(3)
Secure wheel assembly (1) on pivot (6) with screws (5), flatwashers (4), lockwashers (3) and nuts (2).
2-263
|
