|
| |
TM 10-4320-342-24
2-80. CONTROL BOX (ENCLOSURE) REPAIR - continued.
b.
DISASSEMBLE. Refer to Figure 2-108.
(1) Remove screw (1), locknut (2), flatwashers (3) and lanyard (4) from control box (5).
(2) Remove screw (6), nut (7), flatwasher (8) and lanyard (4) from control panel (9).
(3) Remove split washer (10), turn lock stud (11) and sealing washer (12) from control panel (9).
(4) Remove screw (13), nut (14), flatwasher (15) and control panel (9) from control box (5).
(5) Remove locknut (16), flatwasher (17), screw (18), flatwasher (19), spacer (20) and door latch (21) from control
box (5).
(6) Remove split washer (22), turnlock stud (23) and sealing washers (24) from control box cover (25).
(7) Remove foams (26, 27, 28 and 29) from control box cover (25).
(8) Remove foams (30, 31, 32, 33, 34 and 35) and grommet (36) from control box (5).
c.
REPAIR.
Repair is replacement of damaged components. Refer to Appendix D for manufacture of foam replacement and
grommet.
d.
ASSEMBLE.
(1) Using adhesive, install grommet (36) and foams (26, 27, 28, 29, 30, 31, 32, 33, 34 and 35) on control box (5).
(2) Install turnlock stud (23), sealing washers (24) and split washer (22) on enclosure box cover (25).
(3) Install screw (18), flatwasher (19), spacer (20), door latch (21), flatwasher (17), locknut (16) on enclosure box (5).
(4) Install screw (13), flatwasher (15), nut (14) and control panel (9) on enclosure box (5).
(5) Install turnlock stud (11), sealing washer (12) and split washer (10) on control panel (9).
(6) Install screw (6), lanyard (4), flatwasher (8) and locknut (7) on control panel (9).
(7) Install screw (1), flatwashers (3), locknut (2), lanyard (4) and locknut (2) on control box (5).
2-249
|
