|
| |
TM 10-4320-342-24
2-66. TOGGLE SWITCHES (FUEL HEAT, ENGINE PUMPS, START, PUMP CLUTCH
REPLACEMENT TYPICAL.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Sect III,
Battery disconnected (Para 2-61)
Item 1)
Material/Parts
Tag (App E, Item 16)
NOTE
This procedure covers the replacement of the PUMPCLUTCH switch. Replacement
of the other three toggle switches is identical.
a. REMOVAL. Refer to Figure 2-93.
(1)
Open and lock in place cover (1).
(2)
Open control panel (2).
(3)
Tag electrical wires (3).
(4)
Remove screws (4), lockwashers (5) and electrical wires (3) from toggle switch (6).
(5)
Remove compression nut (7) and extension (8) from toggle switch (6).
(6)
Remove nut (9), index ring (10), toggle switch (6) and star washer (11) from control panel (2).
b. INSTALLATION.
(1)
Install star washer (11) on toggle switch (6) and secure on control panel (2) with index ring (10) and nut (9).
(2)
Install compression nut (7) and extension (8) on toggle switch (6) and tighten compression nut.
(3)
Position wires (3) on toggle switch (6) and secure with lockwashers (5) and screws (4) as tagged during removal.
(4)
Close control panel (2) and lower cover (1).
2-220
|
