|
| |
TM 10-4320-342-24
2-45. STARTER-GENERATOR REPLACEMENT. I
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Sect III,
200/600 GPM Pump shut down (Para 2-7c,
Item 1).
TM 10-4320-342-10)
Torque Wrench: 0-200 inch-pounds (App B,
Sect III, Item 2
Material/Parts
Tag (App E, Item 16)
a. REMOVAL. Refer to Figure 2-72.
(1)
Open doors (1 and 2).
(2)
Tag electrical wires and remove nuts (3) and flatwashers (4) from starter-generator (5).
(3)
Loosen nut (6) and lift bracket (7) on clamp (8).
(4)
Remove starter-generator (5) and clamp (8).
(5)
Remove nuts (9) from studs (10).
(6)
Remove housing (11) from engine (12).
b. INSTALLATION.
(1)
Position housing (11) on engine (12).
(2)
Install nuts (9) on studs (10).
(3)
Position clamp (8) on housing (11) for installation of starter-generator (5).
(4)
Position starter-generator (5) on housing (11).
(5)
Install clamp (8) on starter-generator (5) and torque nut (6) to 33 to 37 inch-pounds.
(6)
Tap clamp (8) outer diameter with rubber mallet and retorque clamp nut to 47 to 43 inch-pounds.
(7)
Repeat tap and retorque until torque remains at 47 to 53 inch-pounds.
2-172
|
