|
| |
TM 10-4320-342-10
2-2. LOCATION AND USE OF CONTROLS AND INDICATORS - continued.
Key
Control or Indicator
Function/Use
14
Circuit Breakers (continued)
(b)
BAT HTR Circuit Breaker. Battery heater circuit
breaker opens if more then 50 amperes are drawn
from the battery heater.
(c)
SENSING Circuit Breaker Circuit breaker opens
if ESU draws more than 5 amperes.
(d)
GEN Circuit Breaker. Generator circuit breaker
opens when generator provides more than 35
Amperes of output.
15
Oil Level Indicator (Speed
Indicates level of oil in speed reducer oil reservoir.
Reducer)
16
Winch Control Handle
Handle is used to engage or disengage winch mechanically.
Winch is disengaged (freewheeling) when handle is in
forward position and engaged when handle knob points
toward the control panel.
17
Winch Control Box
Winch box control with two directional control switches
used to extend and retract winch cable.
18
Oil Filter Clogged Indicator
Red indicates when filter elements are clogged. Gold
indicates filter is operating properly.
19
Electronic Sequence Unit
Controls electronics of engine for operating and for Built in
Test Equipment (BITE). There are four indicators that
define malfunctions.
20
200/600 GPM Fuel Pump BALL
Hand operated ball valve used to isolate fuel of the suction
VALVE
side (low pressure of the pump assembly) from the
discharge side to prevent backflow when pump is shut
down. Valve must be open to pump fuel.
21
Priming Vent Drain Tank
Valve is used to return fuel, accumulated in tank during
Valve
priming process, back to the system. When tank is
empty, valve must be closed (vertical position). Fuel tank
should be emptied after each startup to prevent overflow of
tank.
22
FUEL SELECTOR VALVE
Valve for using external fuel or internal fuel (fuel in
transfer lines) for engine.
23
PRIMING SHUT OFF VALVE
ON/OFF two-way ball valve used to prime 200/600 GPM
fuel pump. Fuel valve must be open for priming. After
priming, valve is shut off manually.
2-5
|
