|
| |
TM 10-4320-342-10
CHAPTER 2
OPERATING INSTRUCTIONS
PARAGRAPH
TITLE
PAGE
Section I.
Description and Use of Operator's Controls and Indicators.............................
2-1
2-1.
Introduction ...........................................................................................................
2-1
2-2.
Location and Use of Controls and Indicators .......................... ...............................
2-2
Section II.
Preventive Maintenance Checks and Services (PMCS) ....................................
2-7
2-3.
Introduction ....................................................................................................
2-7
2-4.
General Maintenance Procedures .........................................................................
2-8
2-5.
PMCS Table ....................................................... ..................................................
2-9
Section III.
Operation Under Usual Conditions ............................... ....................................
2-34
2-6.
Assembly and Preparation for Use ........................................................................
2-34
2-7.
Operating Procedures ...........................................................................................
2-41
2-8.
Decals and Instruction Plates ................................................................................
2-44
2-9.
Preparation For Movement ........................................ ...........................................
2-46
Section IV.
Operation Under Unusual Conditions ............................. ..................................
2-50
2-10.
Operation in Extreme Heat ........................................ ...........................................
2-50
2-11.
Operation in Saltwater Areas ....................................... .........................................
2-50
2-12.
Operation in Dusty Areas ........................................ ..............................................
2-50
2-13.
Emergency Procedures .........................................................................................
2-50
2-14.
Decontamination Procedures ........................................ ........................................
2-50
Section I.
DESCRIPTION AND USE OF OPERATOR'S CONTROLS
AND INDICATORS
2-1. INTRODUCTION.
This section provides the operator with information needed to locate, identify, and use the controls and indicators on the
200/600 GPM Pump.
2-1
|
