|
| |
TM 10-4320-324-14
(23) Using oil, lubricate working surface of cylinder
and piston (79). Apply grease to shim surface
and place at least one shim (80) (0.0079 inch
(0.2 mm)) thick on cylinder liner. Install
cylinders.
NOTE
Long side of connecting rod goes toward the camshaft.
(24) Using a ring compression sleeve install
connecting rods and pistons (78) so arrow on
piston points to side of cylinder recessed for
push rod tubes.
(25) Install connecting rod caps (77) using bolts
(76). Preload bolts (71) to 22 lb-ft (30 Nm).
Stage 1 angle is 60°. Stage 2 angle is 300.
Total is 90°.
6-27
|
