| |
TM 10-4320-324-14
a.
Removal.
(1) Place container with minimum of 10 oz. (296 cu. cm) capacity under oil drain plug (1). Remove plug and
drain oil. Dispose of oil according to local regulations.
WARNING
Drive end assembly weighs approximately 100 lbs (46 kg). Attach suitable lifting device prior to removal
or installation to prevent possible injury to personnel.
(2)
Remove 12 nuts (2), 12 lockwashers (3), and drive end assembly (4) from pump end assembly (10).
(3)
Remove and discard gasket (5).
(4)
Remove wear ring (6) from pump end assembly (10).
NOTE
Remove screws and lockwashers from clamping ring not from taper lock hub. Bolts threaded in hub would
be too small of a diameter to aid removal of drive end assembly.
(5)
Remove two screws (7) and two lockwashers (8), diagonally opposite, from clamping ring (11).
5-79
|