|
| |
TM 10-4320-324-14
b. Testing.
(1)
Perform starter solenoid ammeter test.
(a)
Connect positive battery cable to one side of the
ammeter and the negative battery cable to solenoid
ground.
WARNING
Ensure switch is open prior to connecting to starter
solenoid. Electrical shock may result solenoid is
energized while making final battery connection.
(b)
Connect switch leads to ammeter and solenoid switch
terminal (S).
(c)
Connect voltmeter leads to solenoid ground and
solenoid switch terminal (S).
(d)
Connect carbon pile across positive and negative
battery terminals.
(e)
Close switch and adjust carbon pile until voltmeter
indicates 11 VDC.
(f)
Observe ammeter reading. If reading is below or above 120 to 210 amps, replace starter solenoid. If
solenoid is good, install new starter assembly per paragraph 4-36.
c. Assembly.
(1)
Attach starter solenoid (4) with three screws (3).
(2)
Install clamp (2) and screw (1).
d. Follow-on Maintenance.
Install starter assembly (para 4-36).
END OF TASK
5-17
|
