|
| |
TM 10-4320-324-14
WARNING I
Drinking water transfer pump internal components must not be sprayed with preservative oil specified for
the fuel transfer pumps. Failure to heed this warning can result in severe illness or death.
(4) Thoroughly spray interior of drinking water transfer pump, through suction and discharge connections and
priming connection, with petrolatum preservative, Type 14, MIL-C-10382C, in accordance with MIL-
P10603D.
(5) Thoroughly spray interior of fuel transfer pump, through suction and discharge connections and priming
connection with preservative oil, MIL-P-52144D, paragraph 5.2.1.3.
(6) Install all caps and plugs.
(7) Close suction and discharge valves.
(8) Seal intermediate bracket shields with tape (PP-T-60).
NOTE
No special preservative oil is required for pump intermediate bracket.
(9) Remove vent/filler fitting at top of pump intermediate bracket and fill bracket with lubricating oil OE/HDO
30.
e.
Engine Combustion Chambers, Valves, Air Cleaner, Cooling Air System.
NOTE
Do not allow engine to fire during this operation.
(1) Remove air cleaner cover and cartridges.
(2) Remove air cowling.
(3) Spray inside of air cowling, elements covered by cowling, and air cleaner interior with preservative oil MIL-
L-21260.
(4)
Install air cowling.
(5) Install air filter cartridges and cover.
(6) Disconnect air intake hose from intake manifold.
(7) Seal air intake hose from intake manifold.
(8) While rotating engine by hand, through at least twelve complete revolutions, spray approximately two
ounces of preservative oil, MIL-L-21260, into the intake manifold, allowing oil to coat valves and
combustion chamber.
4-197
|
