|
| |
TM 10-4320-324-14
b.
Removal.
WARNING
Do not remove oil sending unit while engine is hot. Engine oil is extremely hot and severe injury to
personnel may result.
(1) Remove banjo bolt (1) and gasket (2).
(2) Remove oil pressure switch (3), pipe tee (4), oil sending unit (5) as an assembly. Remove lockwasher (6).
(3) Remove oil sending unit (5).
c.
Installation.
(1) Install oil sending unit (5) to pipe tee (4).
(2) Install flat washer (9), wire (8), and nut (7).
(3) Install new lockwasher (6).
(4) Install oil sending unit (5), pipe tee (4), and oil pressure switch (3) as an assembly.
(5) Install new gasket (2) and banjo bolt (1).
d.
Follow-on Maintenance. Connect negative battery cable (para 4-30).
END OF TASK
4-164
|
