|
| |
TM 10-4320-324-14
(3) Install bolt (3) and remove seal (5).
(4) Remove bolt (3).
b.
Installation.
(1)
Lubricate lip of seal (1) with grease.
(2)
Position seal (1) in cover (2) with lip inward and
install seal.
(3)
Check that edge of seal (1) is flush with outer
edge of cover (2).
(4) Aline hole in pulley (3) with pin in crankshaft
gear wheel, then slide pulley into position.
(5) Install flat washer (4), then thread bolt (5) into
crankshaft.
(8) Install v-belt pulley holding wrench (6). Refer to
Table 6-1 for correct torque for bolt (5).
NOTE
Bolt securing pulley to crankshaft has
lefthand threads.
c.
Follow-on-Maintenance. Install cooling blower
belt (para 4-34).
END OF TASK
4-153
|
