| |
TM 10-4320-324-14
4-37. V-Belt Contact Switch Replacement (CONT).
b.
Testing.
(1) Connect one lead of electrical circuit tester to terminal of switch and other lead to body of switch.
(2) Check for continuity with switch in operated and nonoperated condition.
(3) If switch registers continuity or an open circuit in both conditions, switch is defective and must be replaced.
(4) Connect lead of tester to other terminal of switch. Repeat steps (2) and (3) to test remaining circuit of switch.
b.
Installation.
(1) Install switch (3) and nut (2).
NOTE
Wires must connect to DIRECT OPPOSITE terminals of v-belt contact switch.
(2) Connect wires (1) to switch (3).
c.
Follow-on Maintenance. Install v-belt guard (para 4-31).
END OF TASK
4-112
|