|
| |
TM 10-4320-324-14
4-29. Battery Box and Cover Replacement.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Tools
General Safety Instructions
Tool kit, general mechanics: automotive, item 32,
Wear safety goggles and rubber gloves while
section III, appendix B
performing maintenance.
Materials/Parts
Do not wear any jewelry while performing
Grease, automotive and artillery, item 5,
maintenance. Jewelry can catch on equipment
appendix E
causing injury or can short out causing burns or
Lockwasher (8) - MS35338-44
starting a fire.
Pins, cotter (2) - MS24665-151
Do not short out battery terminals while
performing maintenance. Sparks can start a
fire.
a.
Removal.
WARNING
Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around vehicle.
Jewelry can catch on equipment and cause injury, or may short across an electrical circuit and cause severe
burns or electrical shock.
Be careful not to short out battery terminals. Do not smoke or use open flame near batteries. Batteries may
explode from a spark. Battery acid is harmful to skin and eyes.
(1) Remove two wing nuts (1), two flat washers (2), strap (3), and two covers (4).
(2) If damaged, remove two cotter pins (5), two straight pins (6), and two bolts (7).
CAUTION
Remove negative (-) battery cable first to prevent possible electrical arc. Failure to comply may result in damage to
batteries and/or cables.
(3) Loosen four battery terminals (8) and remove two cables.
(4) Remove two batteries (9).
(5) Remove eight nuts (10), eight lockwashers (11), eight flat washers (12), and eight screws (13).
(6) Remove two boxes (14).
4-94
|
