|
| |
TM 10-4320-324-14
1-4. Reporting Equipment Improvement Recommendations (EIRs).
If your pumping assembly needs improvement, let us know. Send us an EIR. You, the user, are the only one who can tell us what
you don't like about your equipment. Let us know why you don't like the design or performance. Put it on an SF 368 (Quality
Deficiency Report). Mail it to us at: Commander, US Army Aviation and Troop Command, ATTN: AMSAT-I-MDO, 4300 Goodfellow
Boulevard, St. Louis, MO 63120-1798. We'll send you a reply.
1-5. Warranty Information.
These two pumping assemblies are not warranted.
1-6. Nomenclature Cross-Reference List.
The following nomenclature is used instead of the official nomenclature in this manual.
Common Name
Official Nomenclature
Pumping assembly
Pumping Assembly, Flammable Liquid, Bulk Transfer
Pumping assembly
Pump Unit, Centrifugal
1-7. List of Abbreviations.
Abbreviations used in this manual are as follows:
Abbreviation
Nomenclature
m ..................................... meter
mm ................................. millimeters
cm ................................... centimeters
TDC ................................ top dead center
BDC ................................ bottom dead center
N m ................................. Newton meters
RPM ................................ revolutions per minute
amp ................................ ampere
dc .................................... direct current
psi ................................... per square inch
psig ................................. pounds per square inch gage
"Hg" ................................ inches of mercury
Kg .................................... kilograms
hp ................................... horsepower
mph ................................ miles per hour
VDC ................................ volts direct current
1-8. Calibration.
All calibration procedures are included in the maintenance procedure where they are accomplished.
Change 1
1-3
|
