|
| |
TM 10-4320-316-14
4-21. BAFFLES REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Materials Required
None
Equipment Condition
DED pump assembly shut down and cool.
Air intake hose removed (see paragraph 4-16).
Outlet enclosure assembly removed (see paragraph 4-23).
a. Removal. (Refer to Figure 4-10).
(1) Remove three screws (1) and muffler baffle assembly (2).
(2) Pull the rope T-handle (3) slowly, turning the crankshaft until approximately two feet of pull rope (4) is
exposed.
(3) Grasp the rope (4) firmly and pull the knot (5) in the rope about six inches out of the T-handle (3).
CAUTION
With knot untied do not allow rope to rewind into the starter assembly.
(4) Untie the knot (5) and remove T-handle (3).
(5) Pass the rope (4) through the grommet (6) in baffle (5). Slip the T-handle (3) onto the rope (4) and tie knot (7)
in rope.
(6) Allow the rope (4) to rewind until the T-handle (3) seats on the recoil start assembly.
(7) Remove four screws (8) and baffle (5).
4-34
|
