|
| |
TM 10-4320-316-14
4-15.
CONTROL ASSEMBLY REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Materials Required
None
Equipment Condition
DED pump assembly shut down and cool.
Outlet enclosure assembly tilted open (see para 4-23).
a. Removal (Refer to Figure 4-4).
(1) Disconnect end of control assembly (1) from regulator handle (2) on engine.
(2) Loosen nut (3) and slide nut and washer (4) down the length of the control assembly (1) cable and remove nut
and washer.
(3) Remove control assembly (1) through top of unit.
b. Installation.
NOTE
Be sure throttle handle is fully inserted into cable housing before installing control
assembly into unit.
(1) Feed cable of control assembly (1) through top of unit.
(2) Slide nut (3) and washer (4) up the length of the control assembly cable (1) and install and tighten nut onto
control assembly.
(3) Reconnect end of control cable onto regulator handle (2) of engine.
4-22
|
