|
| |
TM 10-4320-316-14
4-14. COMPRESSION RELEASE HANDLE REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Material's Required
None
Equipment Condition
DED pump assembly shut down and cool.
a. Removal. (Refer to Figure 4-3).
(1) Remove push on nut (1) from compression release handle (2).
(2) Remove compression release handle (2) from the compression release lever (3) on the engine.
(3) Remove compression release handle (2) from unit.
(4) Remove molded cap (4) from compression release handle (2).
(5) Remove grommet (5) from unit.
b. Installation.
(1) Install grommet (5) into unit.
(2) Install compression release handle (2) through grommet (5).
(3) Install molded cap (4) onto compression release handle (2).
(4) Insert compression release handle (2) into hole of compression release lever on engine.
(5) Attach push on nut (1) to end of compression release handle (2) to hold handle onto engine compression
release lever.
4-20
|
