|
| |
TM 10-4320-316-14
SECTION III. OPERATOR MAINTENANCE PROCEDURES
3-5. GENERAL. This section contains the maintenance procedures which the Maintenance Allocation Chart authorizes
the operator to perform. If the DED pump assembly still does not operate properly after performing these maintenance
procedures, contact unit maintenance for assistance.
3-6. SERVICING FUEL INLET FILTER. To service the fuel inlet filter, perform the following steps. (Refer to Figure
3-1.)
a. Removal
(1) Remove fuel tank cap (1) from fuel tank (2)
(2) Remove fuel inlet filter (3) from fuel tank (2).
b. Servicing.
(1) Remove any debris that has collected inside the fuel inlet filter (3).
(2) If fuel inlet filter cannot be cleaned, contact unit maintenance for a replacement filter.
c. Installation.
(1) Install fuel inlet filter (3) into fuel tank (2)
(2) Install fuel tank cap (1) onto fuel tank (2).
Figure 3-1. Servicing Fuel Inlet Filter.
3-5
|
