|
| |
TM10-4320-316-14
CHAPTER 6
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
SECTION I. GENERAL SUPPORT REPAIR PARTS, SPECIAL TOOLS, TEST
MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE),
AND SUPPORT EQUIPMENT
6-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
6-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. The special tools required to service the centrifugal
pump are listed and illustrated in TM10-4320-316-24P, Repair Pars and Special Tools List (RPSTL), and in the
Maintenance Allocation Chart (MAC) located in Appendix B of this manual.
6-3. REPAIR PARTS. Repair parts are listed and illustrated in TM10-4320-316-24P.
SECTION II. GENERAL SUPPORT MAINTENANCE PROCEDURES
6-4. GENERAL SUPPORT MAINTENANCE PROCEDURES. Maintenance procedures at general support maintenance
level include as necessary: removal, cleaning and inspection, repair or replacement, and installation. Unless the
procedure requires special resources or tools, more than one maintenance person or specific equipment conditions,
these are not listed for each maintenance procedure. They are listed only for those procedures that require them.
6-1
|
