|
| |
TM10-4320-316-14
4-36.
OIL CAP/GAUGE REPAIR AND REPLACEMENT.
This Task Covers:
a.
Removal
b.
Repair
c.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Material’s Required
O-ring, (Refer to TM10-4320-316-24P)
Equipment Condition
DED pump assembly shut down and cool.
Inlet enclosure removed (see paragraph 4-22).
NOTE
Engine is equipped with two oil/cap gauges.
a.
Removal. (Refer to Figure 4-29).
(1)
Remove oil cap/gauge (1) from engine crankcase (2).
(2)
Remove O-ring (3) from oil cap/gauge (1). Discard O-ring.
(3)
Remove plug (4) and washer (5).
b.
Repair.
Repair is limited to replacement of defective parts.
c.
Installation.
(1)
Install washer (5) and plug (4).
(2)
Install new O-ring (3) onto oil cap/gauge (1).
(3)
Install oil cap/gauge (1) into engine crankcase (2).
4-82
|
