|
| |
TM 10-4320-316-14
4-33. RECOIL STARTER AND COOLING FAN CASE REPAIR AND REPLACEMENT. - Continued.
b Inspection.
(1)
Pull the rope. It should pull easily with no binding.
(2)
Observe the drive mechanism. The cam that engages the flywheel cap should extend freely.
(3)
Allow the rope to retract. The engaging mechanism should retract.
c. Repair.
Repair of recoil starter is limited to replacement of defective parts.
d. Installation.
(1)
Install cover (9) and screw (8).
(2)
Place seal (7) and cooling fan case (6) into position on engine.
(3)
Install four rubber cushions (5), four collars (4), and four screws (3).
(4)
Check the recoil starter (2) for operation before installing it on the engine.
(5)
Position the recoil starter (2) on the cooling fan case (6) as noted at removal. Push the cam back into the
assembly if it is extended.
(6)
Install four bolts (1) and baffle (see paragraph 4-21).
(7)
Check recoil starter (3) for operation on the engine.
4-76/(4-77 Blank)
|
