|
| |
TM 10-4320-311-14
4-17. Inspect/Replace Electrical Controls and Indicators.
This task covers:
a.
Inspection
b.
Removal
c.
Installation
INITIAL SETUP
Tools
Equipment
Condition
Tool Kit, General Mechanics (Item 1,
Para
Appendix B, Section III)
4-16
Sound enclosure cover assembly
Solder Gun (Item 2, Appendix B,
removed.
Section III)
Material/Parts
Solder (Item 11, Appendix E, Section II)
Flux (Item 12, Appendix E, Section II)
Figure 4-10. Replacing Intervehicle Connector
INSPECTION' Refer to Figure 4-10
Inspect the intervehicie connector (3), located at the lower left of the sound enclosure panel, for damage.
Replace if damaged
REMOVAL:
a.
Remove four hex nuts (1) and four machine screws (2) securing intervehicie connector (3) to sound enclosure
rear panel assembly (4)
b.
Locate terminal block (5) below intervehicie connector (3) at lower right rear of frame (6)
c.
Observe and note the locations of the wire leads secured to terminals 3 and 5 of the terminal block (5)
d.
Remove two screws (7) securing Intervehicle connector wire leads (8) to terminals 3 and 5 of terminal block (5)
e.
Remove intervehicie connector (3) from sound enclosure rear panel assembly (4).
4-27
|
