|
| |
TM 10-4320-311-14
c.
Refill engine crankcase with approximately 0.75 quart of the proper viscosity lube oil. (Refer to Appendix H )
d.
With engine sitting level, remove dipstick (1), and wipe clean with a lint-free cloth (Appendix E, Section II, item
6).
e.
Replace dipstick (1) into oil pan (2).
f.
Add or drain oil until oil level Is within the operating range on dipstick (1)
g.
Replace dipstick (1) all the way into oil pan connection, then tighten the dipstick.
Section II. OPERATOR TROUBLESHOOTING PROCEDURES
INDEX
Para
Page
3-2
Introduction ...........................................................................................................................
3-2
3-2. Introduction.
a.
The table lists common malfunctions which you may find during the operation or maintenance of the (pumping
unit) or its components. You should perform the tests/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests or Inspections and corrective actions. If a
malfunction Is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-2
|
