|
| |
TM 10-4320-311-14
(3)
Add or remove shims (7) to achieve a timing of 14 degrees, plus or minus 1 degree before top dead
center.
(4)
Install fuel Injection pump and repeat test.
b. Fuel Injection Volume Limitation Adjustment.
(1)
Refer to Figure 5-5. Loosen hex nut (2) and remove pump viewing access plate (3) and gasket (4).
(2)
Refer to Figure 5-6. Adjust speed control lever handle until the control lever pointer (2) lines up with
access hole match marks (1).
Figure 5-8. Fuel Injection Volume Limitation Adjustment
(3)
Refer to Figure 5-8. Adjust the fuel limiter adjust screw (1) until the tip lightly touches the governor lever
(2).
(4)
Refer to Figure 5-5. Install pump viewing access plate (3) and gasket (4), and tighten hex nut (2).
5-19
|
