|
| |
TM 10-4320-311-14
5-11. Replace/Inspect/Repair Pump Casing
This task covers:
a)
Removal
c)
Repair
b)
Inspection
d)
Installation
INITIAL SETUP
Tools
Materials/Parts
Tool Kit, General Mechanics (Item 1,
Cloth, Lint-free (Item 6, Appendix E
Appendix B, Section III)
Section II)
Hex Key Drive (Item 3, Appendix B,
Teflon Tape (Item 7, Appendix E,
Section III)
Section II)
Torque Wrench, 0-75 ft-lb (Item 3,
Threaded Inserts
Appendix B, Section II)
Self-Sealing Screws
Tool Kit, Screw Thread Insert,
5/16 x 18 UNC (Item 3, Append ix B,
Equipment
Section III)
Condition
Para
Tool Kit, Screw Thread Insert,
1/4 x 20 UNC (Item 3, Appendix B,
4-22
Suction/discharge removed.
Section III)
4-23
Check valve assembly and suction/
discharge pipes removed.
Tool Kit, Screw Thread Insert,
1/2 x 13 UNC (Item 3, Appendix B,
Section III)
4-30
Flywheel and cooling case
cover removed.
5-10
Impeller, wear plate, shaft seal, and shaft
adapter removed.
REMOVAL, Refer to Figure 5-2.
a.
Remove hose clamp (1) and hose, elbow (2), and bushing adapter (3).
b.
Remove pipe plug (4) and bushing adapter (5).
c.
Remove and discard four self-sealing screws (6).
d.
Separate pump casing (7) from engine.
INSPECTION:
a.
Wipe surface areas with clean, dry cloth.
WARNING
When using compressed air, always use chip guards and wear eye protection.
b.
Inspect all surfaces and edges for cracks.
5-8
|
