|
| |
TM 10-4320-311-14
REPAIR:
WARNING
Wear safety goggles during blind rivet removal to protect your eyes from flying metal chips.
Use hand blind riveter and MS20426AD4-6 rivets to replace missing rivets.
REMOVAL:
a.
Drill out all rivets (5) securing the damaged component.
b.
Remove the damaged components.
WARNING
Toluol solvent Is potentially dangerous. Avoid repeated and prolonged breathing of vapors and
skin contact. Do not use near open flame, arching equipment, or other ignition sources. Always
wear safety goggles for eye protection from splashing. Gloves should be worn during use of
solvent.
c.
To remove damaged plastic foam (4), pull the plastic foam firmly away from the storage chest. Approximately
1/8 inch of plastic foam and adhesive backing will remain.
d.
Apply Toluol solvent to plastic foam and backing to thoroughly wet surface area.
e.
Let set for 2 to 3 minutes.
f.
Using putty knife, peel adhesive backing from surface of the storage chest. Apply additional Toluol as needed.
INSTALLATION:
a.
Align the component fastening holes.
b.
Use blind hand riveter and MS20426AD4-6 rivets to secure component.
c.
To replace plastic foam (4), wipe surface area of the storage chest with a clean cloth dampened in Toluol
solvent, and immediately wipe solvent from surface with a clean, dry cloth.
d.
Fabricate appropriate plastic foam (4). Refer to Appendix F for replacement.
e.
Peel off protective backing.
f.
Place acoustical foam over prepared areas, in correct position, and press firmly in place.
4-71
|
