|
| |
TM 10-4320-311-14
SERVICE:
a.
Thoroughly wash the fuel injection pipe (3) in diesel fuel. Insure that line is clear.
b.
Wipe with clean, lint-free cloth.
INSTALLATION:
a.
Position fuel injection pipe (3) between fuel injection nozzle (2) and fuel injection pump (1). Position the pipe so
that the fittings line up.
b.
Carefully hand tighten pipe connectors. Tighten slowly, taking care not to strip the fittings.
NOTE
Air can enter the fuel pipe system when the engine Is first Installed, the fuel pipe removed, etc. No
air bleeding will be required when the fuel tank runs out of fuel. Bleed the air according to the
following instructions:
(1)
Place the speed control handle in the run position.
(2)
Set the decompression lever to the non-compression position.
(3)
Make sure fuel comes out from the fuel injection nozzle while the recoil starter is pulled. The injection
sound can be heard.
INSPECTION:
Carefully inspect the fuel injection pipe connections for leaks Tighten as necessary.
4-54
|
