|
| |
TM 10-4320-307-10
2-5
OPERATING PROCEDURE (CONT)
k.
Stopping/Shutdown Procedure.
NOTE
Instructions for sto pping operation are located on the control panel assembly.
(1)
Gradually reduce discharge pressure to idle by turning ENGINE/PUMP CONTROLLER knob
counterclockwise.
(2)
Allow engine to idle for 30 seconds.
(3)
Set MODE CONTROL switch to MANUAL.
(4)
Disengage clutch (down position).
(5)
Close discharge and suction valves.
(6)
Wait one minute and then pull ENGINE STOP switch.
(7)
Set POWER ON/OFF switch to OFF.
(8)
Set PANEL LIGHT ON/OFF switch to OFF.
(9)
Perform operator PMCS (Table 2-2).
2-6
PREPARATION FOR MOVEMENT.
a.
Shut down pumping assembly in accordance with paragraph 2-5k.
b.
Be sure discharge and suction valves are closed.
c.
Drain the discharge pipe into a suitable container and remove discharge pipe from pump flange.
d.
Drain the suction pipe into a suitable container and remove suction pipe from pump flange.
e.
Cover the pump discharge and suction flanges to keep debris from entering the pump.
f.
Disconnect ground rod cables and remove ground rods from earth. Stow cable assembl ies in
storage box. Stow ground rods.
g.
Be sure that battery box and storage box are securely closed.
2-66
|
