|
| |
OVERVIEW . .
Section I.
Section Il.
Section Ill.
OVERVIEW
TM 10-4320-256-14&P
CHAPTER 1
INTRODUCTION
Page
1-1
. . . . . . . . . . . . . . . . . . . . . . . . . .... . . . . .. . . .. . .. . . .
General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-1
Equipment Description and Data.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-3
Principles of Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-5
This chapter contains general informatbn common o all Army equipmentand specific information per’tinenttothe -
equipment covered by this manual.
Section I. GENERAL INFORMATION
Paragraph
Page
1-1
Scope . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-1
1-2
Maintenance Forms and Records. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-3
1-3
Destruction o fArmyMaterie to Prevent Enemy Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3
1-4
Preparation or Storage or Shipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...1-3
1-5
Reporting Equipment Improvement Recommendations . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3
1-1. Scope. The scope of this manual is described in the following subparagraphs.
a. Type of Manual. This manual provides operator, unit, direct support and generalsuppod maintenance
instructions for Pump Assembly, NSN 4320-00-427-0002. This is a gasoline-engine driven, self-priming
centrifugal pump assembly for ONLY pumping flammable Iiquids (figure 1-1). These instructions include
procedures for setting up and operating the equipment underusual and unusual conditions as well as inspection,
Troubleshooting, repair and replacemenent of individual components at assemblies. This manual also providesa
repair parts and special tools list contained in Appendix G.
b. Equipment Name. . Pump Assembly, Flammable Liquid, Centrifugal, Self-Priming, GED, 2-in., 100 GPM,
hereinafter referred to as the pump assembly.
c. Purpose of Equipment. The pump assembly is used to move flammable liquids, under pressure, from one
location to another at height differentials no greater than 25 feet (7.62 meters).
1-1
|
