| |
TM 10-4310-391 -13&P
C.............................................. Operator/Crew
O ............................................. Unit Maintenance
F ............................................. Direct Support Maintenance
H.............................................. General Support Maintenance
D ............................................. Depot Maintenance
e. Column 5. Tools and Equipment Column 5 specifies, by code, those common tool sets (not ndiv-dual
tools) and special tools, TMDE, and support equipment required to perform the designated function.
f Column 6. Remarks. This column shall, when applicable, contain a letter code, In alphabetic order,
which shall be keyed to the remarks contained In section IV
B-4 Explanation Of Columns In Tool And Test Equipment Requirements, Section III .
a Column I Reference Code The tool and test equipment reference code correlates with a code used In
the MAC, section 11, column 5
b. Column 2. Maintenance Category. The lowest category of maintenance authorized to use the tool or
test equipment
c. Column 3 Nomenclature. Name or identification of the tool or test equipment
d. Column 4 National Stock Number The National stock number of the tool or test equipment
e. Column 5 Tool Number The manufacturer's part number.
B-5. Explanation Of Columns In Remarks, Section IV .
a. Column I Reference Code The code recorded In column 6, Section II
b. Column 2. Remarks This column lists information pertinent to the maintenance function being
performed as indicated In the MAC, section II.
Section II. MAINTENANCE ALLOCATION CHART
TM 11-5805-234-12
SECTION II MAINTENANCE ALLOCATION CHART (CONTINUED)
(1)
(2)
(3)
(4)
(5)
(6)
GROUP
COMPONENT/
MAINTENANCE
MAINTENANCE LEVEL
TOOLS AND
NUMBER
ASSEMBLY
FUNCTION
C
O
F
H
D
EQUIPMENT
REMARKS
01
|VACUUM PUMP
SARGENT-WELCH
INSPECT
0.2
SERVICE
0.3
011
PUMPING ASSEMBLY
REPLACE
1.0
1
REPAIR
1.0 4.0
1
A
012
MOTOR
REPLACE
1.0
1
B
REPAIR
1.0
4.0
1,2,3
B-3
|