|
| |
TM 10-3835-231-13
(f) Purge and fill discharge lines from tanks (44) and (46).
1
Open valves (48), (49), (50), (51), (52), and (53).
2
Start pump (54) and operate at low discharge pressures but sufficient to cause flow. Slowly open
valve (47).
3
Continue pumping until sure that the air from the line between valves (48) and (53) has passed valve
(47).
4
Open valves (55) and (56), then close valves (48) and (49).
5
Continue pumping until sure that the air from the line between valves (56) and (55) has passed valve
(47).
6
Shut down pump (54).
7
Close valves in the following sequence: (56), (55), (50), (51), (52), (53), and (47).
WARNING
FUEL SPLASH AND SPILL
Splashes and spills can cause eye injury and skin irritation. Wear face shield and
approved gloves.
WARNING
GROUNDING AND BONDING
The system dispensing valve must be grounded and bonded to the receipt vessel
prior to opening the vessel and dispensing fuel. Static electricity could cause a
fire or explosion.
(g) Purge and fill the discharge lines of tanks (40) and (38), and the lines to and through the fuel dispensing
system and back to the tank farm (module) assemblies. In preparation for the purge and fill of the fuel
dispensing assembly, bring in a collapsible or open drum or deep container to catch the fuel from the
dispensing valves.
2-57
|
