| |
TM 10-3835-231-13
5-7. METER SKID ASSEMBLY REPAIR. - continued
(9)
Remove four each hex nuts (19) and bevel washers (20) and two each U-bolts (21).
(10)
Lift strainer (22) from skid (23).
b.
Repair. Replace all defective parts.
c.
Assembly.
(1)
Place strainer (22) on skid (23) and secure with two each U-bolts (21) and four each bevel washers (20)
and nuts (19).
(2)
Wrap male pipe threads with antisieze tape and install street elbow (18), pipe nipple (17), and combination
nipple (16).
(3)
Place hose (15) on end of combination nipple (16) and secure with clamp (14).
(4)
Wrap male pipe thread with antisieze tape and install street elbow (13), pipe nipple (12), ball valve (11) and
quick disconnect coupling (9).
(5)
Place hose assembly (10) into quick disconnect coupling (9) and close cam arms.
NOTE
Liberally apply petrolatum to the gasket and the inside surface of coupling clamps
when they are installed. This will help avoid pinching the gasket when the clamp is
closed.
(6)
Slip coupling (8) gasket in place on strainer (22).
(7)
Slip meter (3) into place and support square with strainer (22) coupling joint.
(8)
Place coupling (8) over gasket and close coupling handle.
(9)
Secure meter (3) to skid (23) with three each cap screws (5), new lock washers (6) and flat washers (7).
(10)
Place tachometer flow meter (4) between meter (3) body halves and secure with four screws (2).
(11)
Install plastic caps (1).
5-10
|