|
| |
TM 10-3835-231-13
Figure 4-28. Evacuation Process View 1
2
Disconnect the hoseline from the assembly or facility from which it originates. This is done by
removing the coupling clamp. (See figure 4-23.)
3
Slide the gasket away from the center position between grooved fittings. Separate the hoseline
from the facility and remove the gasket.
4
Place the displacement ball inside the end of hoseline adapter.
5
Connect the inlet ball with pneumatic coupler to the hoseline and where the displacement ball
was installed.
4-77
|
