|
| |
TM 10-3835-231-13
4-40. HOSELINE SUSPENSION SET REPAIR.
This task covers:
a. Disassembly
b. Repair
c. Assembly
INITIAL SETUP
Tools
Tool Kit, General Mechanics (Appendix B, Section III,
Item 1).
NOTE
Disassemble only to extent necessary for repair.
a.
Disassembly.
(1)
Unhook wire rope ends from turnbuckle.
(2)
Remove nuts, clamps, and thimble.
(3)
Pull wire rope from shackles.
(4)
Unhook turnbuckle from shackle.
(5)
Remove two shackle bolts, shackle, and anchor stake.
(6)
Remove nut, shackle bolt, shackle, and saddle.
b.
Repair. Replace damaged components only to extent necessary fir repair.
c.
Assembly.
(1)
Install cable and hoseline as follows:
(a)
Drive anchor stake into the ground approximately 15 feet from each tower in line with both towers.
Take should protrude from ground approximately 6 inches. Use the driving head to drive stakes
(figure 4-21).
(b)
Hang a pulley block from each tower and thread wire rope through pulley on near side.
(c)
Pull wire rope across stream or obstruction.
4-64
|
