|
| |
TM 10-3835-231-13
4-11. FUEL DISPENSING ASSEMBLY. - continued
f.
To assemble the 1-1/2 inch dispensing hoses:
(1)
Connect 1-1/2 inch ball valves (21) to tees (1) using couplings (8) gaskets (9) coupling clamps (10) 4
inch female x 2 inch male reducers (22) and gaskets (23) and 2 inch female x 1-1/2 inch male
reducers (24) and gasket (25).
(2)
Connect 1-1/2 inch pressure control valves (26) to ball valves (21).
(3)
Connect 1-1/2 inch x 25 foot hose assemblies (27) to pressure control valve (26).
(4)
Connect remaining 1-1/2 inch ball valves (21) to end of hoses (27).
g.
To assemble the 4 inch filter separator and water detection kit lines:
(1)
Connect 4 inch x 25 foot hoses (11) Cam-lock to tees (1) t: sing coupling clamps (10), gaskets (9),
coupling adapters (28) and gaskets (23).
(2)
Connect 4 inch gate valves (7) to hoses (11).
(3)
Connect water detection kit adapter (29) to gate valve (7).
(4)
Install, service, and prepare the filter separators (30) in accordance with TM 5-4330-211-12.
(5)
Connect filter separators (30) to water detection kit adapters (29) using couplings (8), gaskets (9), and
coupling clamps (10).
(6)
Connect 4 inch gate valves (7) to filter separators (30) using coupling clamps (10), gaskets (9),
coupling adapters (28) and gaskets (23).
(7)
Connect 4 inch x 25 foot hoses (11) Cam-lock to gate valves (7).
(8)
Connect hoses (11) to tees (1) using couplings (8), gaskets (9), and coupling clamps (10).
h.
Locate and install ground rod (31).
i.
Place 8 each drip pans (32), 2 each oil absorbent material (33), and 2 each storage drums (34) where they
will be available for use when needed.
4-30
|
