| |
TM 10-3835-231-13
4-11.
FUEL DISPENSING ASSEMBLY.
CAUTION
INTERNAL CLEANLINESS
Make sure all hoselines, fittings and valves are clean internally. Foreign materials
may disrupt operations and damage equipment.
NOTE
The following assembly instructions apply to one Fuel Dispensing Assembly.
There is one Fuel Dispensing Assembly for each Fuel Unit, for a total of three for a
TPT.
a.
Inspect all items for damage, cleanliness and quantities required.
b.
Determine the approximate location and layout of the dispensing area per established plot plan.
NOTE
Liberally apply petrolatum to the gasket and the inside surface of coupling clamp to
prevent pinching during installation. Then, pull the coupling gasket over one
grooved end of each mating joint. Ensure gasket is properly positioned over full
circumference of sealing surfaces. Position coupling clamp over gasket. While
maintaining alignment of mating parts, lock coupling clamp securely.
c.
Align mating surfaces of 6 x 6 x 4 tees (1) (figure 4-10), 6 inch x 50 foot hose assemblies (2), 6 inch ball
valves (3), 6 inch pressure control valve (4), and 6 inch cap (5). Join these items using coupling clamps (6).
d.
To assemble the 4 inch dispensing hoses:
(1)
Connect 4 inch gate valves (7), to tees (1) using couplings (8), gaskets, (9), and coupling clamps (10).
(2)
Connect 4 inch x 25 foot Cam-lock hoses (11) to gate valves (7).
(3)
Connect 4 inch Cam-lock butterfly valve (12) to hose (11).
e.
Determine dispensing device combination from the following and connect them to butterfly valves (12):
(1)
4 inch male x 3 inch female Cam-lock reducer (13) and gasket (14).
(2)
D-1 nozzle assembly (15) and adapter (16).
(3)
Dry break coupling assembly (17) and dry break tanker truck adapter (18).
(4)
NATO tank truck adapter coupling set (19).
(5)
NATO rail tanker coupling (20).
4-27
|