|
| |
TM 10-3835-219-14
S e c t i o n I l .
O P E R A T O R
T R O U B L E S H O O T I N G
P R O C E D U R E S
Paragraph
3 - 2
3 - 3
3-2. G e n e r a l .
P a g e
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
Operator Troubleshooting Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
This section contains troubleshooting information for locating and correcting the common
malfunctions which may be encountered during the operation or maintenance of the hoseline outfit. The major
trouble that may occur during operation of the hoseline outfit are engine or pump failure, leaks or blockages.
Troubleshooting for the engine and pump is covered in the applicable Technical Manual for the pumping
assembly being utilized. Refer to applicable Technical Manual for troubleshooting of the engine or pump.
3-3. O p e r a t o r T r o u b l e s h o o t i n g P r o c e d u r e s . To troubleshoot the hoseline outfit, refer to
Table 3-1, Troubleshooting.
a. Each malfunction is followed by a list of tests or inspections which will help in determing corrective actions to
take. Perform the tests/inspections and corrective actions in order listed.
b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective action, notify your supervisor.
S Y M P T O M I N D E X
S y m p t om
P a g e
No fuel flow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...... .3-4
Block, tackle, won’t function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . 3-5
Chain, hoist won't function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Gate valve won’t open or close . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . 3-5
Inlet ball won’t pass through hoseline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-5
Table 3-1. Operator Troubleshooting Procedures.
Malfunction
Test or Inspection
Corrective Action
1 .
NO FUEL FLOW.
Step 1.
Inspect hoseline for security of all coupling clamps and rings. Check for
damaged couplings, rings or defective gaskets.
Replace defective parts.
Step 2. Check entire length of hoseline for any breaks, leaks or seepage through hose wall.
Repair hose by using repair kit if defects noted.
Step 3. Check entire length of hoseline for kinks or objects on hoseline.
Remove kinks or objects.
3 -4
|
