|
| |
T M
1 0 - 3 8 3 5 - 2 1 9 - 1 4
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
While preventing stem (13) from turning in bonnet (11), turn discs (15 and 16) and riser
(17) left (counterclockwise) onto stem util top of
b o n n e t.
Position gasket (12) on valve body (18).
While holding stem (13) in position, lower bonnet
discs contact flanged bottom of
(11) and discs (15 and 16) into valve
body (18). Do not rotate discs more than 1/4 turn to aline discs with body.
Install eight flat washers (10), screws (9), Iockwashers (8) and nuts (7) in valve body (18)
and bonnet (11).
Slide packing ring (6) over stem (13) and down into bonnet (11).
Slide packing gland (5) and gland spring (4) over stem (13).
Slide packing nut (3) over stem (13) and tighten onto top of bonnet (11).
Position handwheel (2) on stem (13) and secure with nut (1).
Install gate valve. Refer to figure 6-5.
(12)
(13)
(14)
(15)
(16)
Position gasket (14) and adapter (13) on gate valve (15).
Install eight flat washers (12), screws (11), flat washers (10), Iockwashers (9) and
nuts (8).
Position gasket (7) and adapter (6) on gate valve (15).
Install eight flat washers (5), screws (4), flat washers (3), Iockwashers (2) and
n u t s ( 1 ) .
Install gate valve in fuel system and check for leaks.
Change 1
6-17/(6-18 Blank)
|
