|
| |
TM 10-3835-219-14
(2)
Assembly. (figure 6-3)
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
(n)
(o)
(P)
(q)
(r)
Install load gear (47), two No. 2 gears (46) and load sheave (45) in slide plate B assembly (48).
Attach chain stopper link (44), if removed.
Position bottom hook assembly (43) and safety assembly (27) and secure with chain pin (42), slotted
nut (41) and split pin (40).
install load chain (39), stripper (38), two stripper collars (37) and guide rollers (36).
Position slide plate A assembly (35).
Install friction disc (34), coil spring (33), spring seat (32) and pinion (31).
Install two pawl springs (30), pawls (29) and secure with snap rings (28).
Position top hook assembly (26) and safety lever assembly (27) and secure with top pin (35).
Install one friction pIate (23), ratchet disc (24) and remaining friction plate (23).
Position brake cover (22) to slide plate A assembly and secure with four washers (21) and nuts (20).
Position inside half of lever assembly (14). Then, install female thread assembly (19), change-over
pawl (18), spring shaft (17) and change-over spring (16).
Position outside half of lever assembly (14), with nameplate (15), and secure with three washers (12)
and screws (13).
Install one washer (12), screw (11) and nut (10).
Slide grip (9) on lever assembly.
Install cam guide (8) and free wheeling knob (7).
Install washer (6), slotted nut (5) and split pin (4).
Position gear case (3) and secure with four washers (2) and nuts (1).
Lubricate per paragraph 3-1.c.
6 - 8
|
