|
| |
TM 10-3835-219-14
4-11. Flaking Box Assembly.
This task covers:
Repair
INITIAL SETUP
Tools
Equipment Condition
Drill (Appendix B, Section Ill, item 2)
Hose removed (para. 3-5).
Riveter (Appendix B, Section Ill, Item 3)
Materials/Parts
Solvent, drycleaning (Item 7, Appendix E)
Rags, Wiping (Item 5, Appendix E)
Rivet (TM 10-3835-219-24P)
Pin, Cotter (TM 10-3835-219-24P)
Repair. (Figure 4-1)
(1) Drill out rivets (1) securing four panels (2) to frame (3) and remove panels.
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
Remove cotter pin (4), shackle pin (5) and remove shackte (6).
Remove nut (7) and remove eyebolt (88).
Remove two bolts (9), lift tie bar (10) and remove tie bar.
Lift tailgate (11 ) and remove.
If any frame member requires welding, refer to higher level of maintenance.
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Avoid repeated and prolonged skin contact. Do not use near open
flame or excessive heat. Flash point of solvent is 100°F-138°F (38°C-60°C).
Clean all components with dry cleaning solvent and dry thoroughly.
Inspect shackle pin (5), shackle (6), eyebolt (8) from cracks or breaks and replace if damaged.
Install tailgate (11 ) on tie bar (10).
Position tie bar (10) and secure with two bolts (9).
Install eyebolt (8) and secure with nut (7).
Install shackle (6), shackle pin (5) and secure with cotter pin (4).
Using old panels as template, drill holes in new panels. Secure new panels to frame (3) with rivets(1).
4-4 Change 1
|
