|
| |
TM 10-3835-219-14
3-15. Flow Control Kit Chest Assemblies.
This task covers:
Replace (Model ADC-1200 and 1461)
Replace.
NOTE
The flow control kit chest assemblies are made up of two chest assemblies. One for the
model ADC-1200 and one for model 1461. The replacement of each chest assembly
is the same.
(1) Remove and store components of flow control kit from the chest assembly and store kit.
(2) Inspect chest assembly for damage. Replace chest assembly if damaged, and notify maintenance.
3-16. Roadway Crossing Guard.
This task covers:
Replace
INITIAL SETUP
Tools
Repair Kit (Appendix C, Section II, item 4 or 9) as applicable
Replace. (Figure 3-13)
(1)
(2)
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Avoid repeated and prolonged skin contact. Do not use near open
flame or excessive heat. Flash point of solvent is 100°F-138°F (38°C-60°C).
Clean roadway crossing guard (1) with dry cleaning solvent and dry thoroughly.
Inspect roadway crossing guard (1) and replace if cracked or badly distorted.
Figure 3-13. Roadway Crossing Guard, Replace.
3-22 Change 1
|
