|
| |
TM 9-2330-398-24
3-23. ENGINE THROTTLE AND CHOKE LINKAGE REPLACEMENT (continued).
b.
INSTALLATION
1.
Install throttle cable (4) through channel of control panel (15). Install washer (20), jamnut (19), packing nut (16),
handle (17), and screw (1.8) on throttle cable (4).
2.
Pull throttle cable (4)
through engine shrouding (14).
Install Inside jamnut (13) on
throttle cable (4), but do not
tighten.
3.
Install two washers (10)
and new cotter pins (11) on
throttle linkage (7). Install throttle
linkage (7) on lever (12).
4.
Install jamnut (5) and
clevis (9) on end of throttle cable
(4).
5.
Connect throttle cable (4)
to throttle linkage (7) with clevis
pin (6) and new cotter pin (8).
3-72
|
