|
| |
TM 9-2330-398-24
3-22.
FUEL INJECTION NOZZLE REPAIR (continued),
b.
DISASSEMBLY
1.
Remove spacer plate (7), gasket (8), and adapter (9), and pipe elbow (10) from fuel injector (6). Discard
gaskets.
CAUTION
Never clamp fuel Injector in a vise that has
hardened jaws. Damage to fuel injector
could result
NOTE
When disassembling fuel injectors, take care
to label each component of each fuel injector
being disassembled. Never interchange
components of fuel injectors.
2.
Secure fuel injector (6) in vise with vise jaw caps
and remove injector nozzle cap (19) and nozzle
assembly (21).
3.
Remove gasket (20) from nozzle cap (19). Install nozzle cap (19) loosely on nozzle holder (17) to protect lapped
surface of nozzle holder (17). Discard gaskets.
4.
Remove plug (20) from protective cap (12).
5.
Remove protective cap (12) and copper gasket (13) from adjusting screw (14).
WARNING
Adjusting screw is under pressure. To avoid Injury to
personnel, take care when removing adjusting screw from
nozzle holder.
6.
Remove adjusting screw (14) from nozzle holder (17).
7.
Remove spring (15) and spindle (16) from nozzle holder (17).
8.
Remove adapter (18) from hole holder (17).
3-65
|
