|
| |
TM 9-2330-398-24
Section II. SERVICE UPON RECEIPT
Paragraph
Page
Number
Paragraph Title
Number
2-5
General.................................................................................................................................................2-2
2-6
Inspection Instructions..........................................................................................................................2-2
2-7
Servicing Instructions ...........................................................................................................................2-2
2-5.
GENERAL.
When a new, used, or reconditioned semitrailer is first received, determine whether it has been properly prepared for
service and is in condition to perform its mission. Whenever practical, the operator/crew will assist Unit maintenance
personnel in the performance of these services. Follow the inspection instructions in paragraph 2-6 and the servicing
instructions in paragraph 2-7.
2-6.
INSPECTION INSTRUCTIONS.
a.
Refer to DD Form 1397 for procedures on unpacking the semitrailer.
b.
Remove all straps, plywood, tape, seals, and wrappings.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with
skin, eyes, and clothes--, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat.
c.
Remove rust preventive compound from coated exterior parts of the semitrailer using drycleaning solvent (Item 12,
Appendix C) and rags (Item 25, Appendix C).
d.
Inspect the semitrailer for damage incurred during shipment. Check also to see if the equipment has been
modified.
e.
Check the equipment against the packing list to make sure the shipment is complete. Report any discrepancies in
accordance with instructions in DA Pam 738-750.
2-7.
SERVICING INSTRUCTIONS.
Perform the following overall servicing inspections prior to any Unit, Direct Support, or General Support maintenance:
•
Perform all operator/crew preventive maintenance checks and services (PMCS) (refer to TM 9-2330-398-10)
and all Unit PMCS procedures listed in Table 2-1.
•
Lubricate all lubrication points as described in Appendix G, regardless of interval.
2-2
|
