|
| |
TM 9-2330-398-24
2-120. FILTER SEPARATOR FILTER ELEMENTS REPLACEMENT (M & E INDUSTRIES MODEL) (continued).
3.
Remove seven stay rods (25) and spring tension dip (22) from filter separator (1), if necessary.
4.
Remove nut (17), lockwasher (16), two washers (14), screw (13), and guide bar (15) from retaining plate (20), if
necessary. Discard lockwasher.
c. ASSEMBLY
1.
Install three new gaskets (27, 29, and 31) and monitor mounting plate (28) in filter adapter assembly (30).
2.
Install three filter elements (26) in filter adapter assembly (30).
3.
Install fuse monitor bracket (24) on top of three filter elements (26).
4.
Install filter assembly (23) over three filter elements (26) and push into filter adapter assembly (30).
5.
If removed, install seven stay rods (25) and spring tension clips (22) in filter separator (1).
6.
If removed, install guide bar (15) on retaining plate (21) with screw (13), two washers (14), new lockwasher (16),
and nut (17).
d. INSTALLATION
1.
Coat end of filter element (12) with petrolatum. Install filter element (12) in filter separator (1) and slide into place
on guide pipe.
2.
Install retainer nut (11) and hand-tighten. Do not overtighten.
3.
Repeat steps 1 and 2 install for remaining 14 filter elements (12).
4.
Install filter assembly (23) in filter separator(l) with filter adapter assembly (30) end down. Turn filter assembly (23)
so filter adapter assembly (30) end is toward rear of filter separator (1).
5.
Starting at upper guide rod farthest from service opening (10), install filter assembly (23) in filter separator (1).
6.
Repeat steps 4 and 5 to install remaining four filter assemblies (23).
NOTE
Hand-tighten wingnuts. DO NOT use wrench.
7.
Install retaining plate (21) on five filter assemblies (23) and secure with seven washers (20), new lockwashers
(19), and nuts (18).
8.
Install access cover (8) and new gasket (7) on mounting flange of filter separator (1).
2-261
|
